Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Day Light Savings Command for IPS 4215

What command can I use to make sure that the IPS is configured for Day Light Savings this weekend?

Thanks

4 REPLIES
Silver

Re: Day Light Savings Command for IPS 4215

If your sensor is running above 05.0(06)S247, you dont need to make any changes. This issue was fixed in 05.0(06)S247.

Please refer to bug id: CSCsf22530

Hope this answers your questions.

Regards,

Vibhor.

Cisco Employee

Re: Day Light Savings Command for IPS 4215

But the bug says that it is fixed in 5.1(4), 6.0(1).

Silver

Re: Day Light Savings Command for IPS 4215

Yes .. it was filed for version 05.0(06)S247 and has been taken care of from 5.1 trains.

Regards,

Vibhor.

Cisco Employee

Re: Day Light Savings Command for IPS 4215

My recommendation is to upgrade to 5.1(5) if running 5.1 on your sensors.

The 5.1(4) upgrade put in the new defaults for the new time changes, but there was an IDM bug where the old time changes may have been written as "user" configuration.

The 5.1(5) Service Pack corrects that IDM bug and ensures the new time changes will be used.

If running 5.1(4), 5.1(5), or 6.0(1) then execute:

show conf | begin summertime

It should show:

summertime-option recurring

summertime-zone-name

exit

exit

! ------------------------------

Followed by the rest of your config.

So long as nothing is between the "recurring" and the name, AND you are running 5.1(4), 5.1(5), or 6.0(1) then you are fine because it will use the new defaults for this year.

If it has anything between "recurring" and the summertime-zone-name then it may not be set correctly.

If running 5.1(4) or earlier, then upgrade to 5.1(5) and check it again. 5.1(5) will correct most mis-configurations.

If you are already running 5.1(5) or 6.0(1), then you will likely need to do some correcting manually.

1) conf t

2) service host

3) default summertime-option

4) summertime-options recurring

5) summertime-zone-name

6) exit

7) exit

8) yes to apply changes

9) yes to reboot

125
Views
0
Helpful
4
Replies
CreatePlease login to create content