Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Duplicate Active Signatures to Second Sensor

I have 2 ASA-SSM-20 IPS modules on 2 different ASA 5520s.

I have setup the Signature Definitions for sig0 on Sensor 1 a certain way, how do I make those same policies apply to the sig0 on Sensor 2. I see that I can export the settings as a .csv from Sensor 1, but not how I can import them on Sensor 2?

Any help would be appreciated!

1 REPLY
Gold

Re: Duplicate Active Signatures to Second Sensor

There are several ways of accomplishing that goal. The most basic is from the

CLI. Log into Sensor 1 and display the full config (sh conf).

Log into sensor 2, get in the config mode (conf t) and paste in sensor 1's config for everything after the sig0 heading.

333
Views
0
Helpful
1
Replies
CreatePlease to create content