Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Enable IPS on Router

I enabled IPS on a 2901 router. The signatures are uploaded and it is enabled on an interface. When I goto signatures I get a message box that says "You must first enable IPS before configuring signatures. To enable IPS, go to IPS Policies and enable IPS on any interface." Trouble is I do have IPS enabled.

 

Any Thoughts?

 

This is what was delivered to the router:

 

ip ips notify SDEE
ip ips name sdm_ips_rule
ip ips signature-category
 category all
  retired true
  exit
 category ios_ips advanced
  retired false
  exit
 exit
interface GigabitEthernet0/1
 ip ips sdm_ips_rule in
 ip virtual-reassembly
 exit
interface GigabitEthernet0/0
 ip ips sdm_ips_rule in
 ip virtual-reassembly
 exit
interface Embedded-Service-Engine0/0
 ip virtual-reassembly
 exit
ip ips config location flash0:/IPS/

81
Views
0
Helpful
0
Replies
CreatePlease login to create content