Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

getting start with IPS

We have the IPS module on the ASA, we connected each module to the internal core switch and using the ASDM attempted to give it an IP address and begin the configuration.  However when defining the IP address (along with the username\pw) I get an error msg saying:

"Error connecting to Sensor. Error loading sensor"

Any idea?

Also, do you have any good tips to configure this IPS (SSM10)?

1 REPLY

Re: getting start with IPS

Hi,


Can you enter to the IPS module with the session command from the ASA's CLI?

Please go through this document and let me know if you have any problems.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008080f2d1.shtml

Federico.

341
Views
0
Helpful
1
Replies