I'm pretty new on IPS. I'm trying to put 4240 IPS between my ourter router and FW. Can I connect g0/0 to router and g0/1 to FW? What interface mode should it be running? Is there any other way to do this? I was trying to find some sample config on Cisco website. No luck so far...
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...