Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can I use Local SPAN with RSPAN ??

How can I use Local SPAN with RSPAN ??

I want to mirror traffics from ISP-A and ISP-B to Anomaly-detector module.

so I had configured like this...

C6500-A

vlan 1000

name RSPAN

remote-span

!

monitor session 10 source interface Gi5/1 - 2 rx

monitor session 10 destination remote vlan 1000

monitor session 20 destination anomaly-detector-module 3 data-port 1

monitor session 20 source remote vlan 1000

!

interface GigabitEthernet1/13

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1000

switchport mode trunk

no ip address

!

C6500-B

vlan 1000

name RSPAN

remote-span

!

monitor session 10 source interface Gi5/1 - 2 rx

monitor session 10 destination remote vlan 1000

!

interface GigabitEthernet1/13

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1000

switchport mode trunk

no ip address

end

but it was not working..

it wasn't any change of input packet hit count when

I'd enter a command 'show anomaly-detector module 3 data-port 1 traffic'

was upper configuration wrong..?

Can I use VACL configuration ?

1 REPLY
New Member

Re: How can I use Local SPAN with RSPAN ??

try to change "monitor session 10 destination remote vlan 1000 " to "monitor session 10 destination anomaly-detector-module 3 data-port 1 " on C6500-A

208
Views
0
Helpful
1
Replies