I'm studying the ASA5100 w/ATP-SSM10 and want to clarify how it works. please guide or correct me.
1. Command and control interface=g0/0
2. Sensing interface=vs0 (logical concept. not physical)
3. Promiscuous mode=sends any combination traffic from ASA(even all foure interfaces) to AIP-SSM g0/1
4. Inline mode=Not clear how this works. how can I create the inline PAIR since only one physical interface(g0/1) on the AIP-SSM? the doc says inline supporting by g0/1 and the combination "by security context".
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...