I have a ASA 5510 with a IPS that has duplicate ip address.

[eferland]

And now I can't log into the IPS using Cisco IME. Any way to change the IP address on the IPS from the ASA? 

[eferland]

Result of the command: "hw-module module 1 ip 10.0.0.12 255.255.255.0 10.0.0.254"

hw-module module 1 ip 10.0.0.12 255.255.255.0 10.0.0.254

                                ^

ERROR: % Invalid input detected at '^' marker.

Its pointing at "ip"

Result of the command: "show module 1 details"

Getting details from the Service Module, please wait...

Unable to read details from slot 1

ASA 5500 Series Security Services Module-10

Model:              ASA-SSM-10

Hardware version:   1.0

Serial Number:      JAF1544AEDS

Firmware version:   1.0(11)5

Software version:   7.0(7)E4

MAC Address Range:  7081.0570.f43f to 7081.0570.f43f

App. name:          IPS

App. Status:        Not Applicable

App. Status Desc:   Not Applicable

App. version:       7.0(7)E4

Data plane Status:  Not Applicable

Status:             Unresponsive

[Karsten Iwen]

The right command to use is:

session 1 ip address 10.0.0.12 255.255.255.0

[eferland]

ERROR: Unable to send a command request to slot 1??

[eferland]

Got it!

sensor# configure terminal

sensor(config)# service host

sensor(config-hos)# network-settings

sensor(config-hos-net)# host-ip xx.xx.xx.xx/24,xx.xx.xx.xx

[eferland]

I managed to shutdown the ips which is good because the ip address conflict is with a vm host. Now if I could change the ip address without tuning it back on that would be great. Or somehow copy the config edit it maybe in note pad and reload it.

[eferland]

wrong place

[eferland]

Sonora

meredith Mar 19, 2014 at 10:35 AM

I unplugged the Ethernet cable from the ssm module and fired it back up. 

 ASA 5500 Series Security Services Module-10

Model:              ASA-SSM-10

Hardware version:   1.0

Serial Number:      JAF1544AEDS

Firmware version:   1.0(11)5

Software version:   7.0(7)E4

MAC Address Range:  7081.0570.f43f to 7081.0570.f43f

App. name:          IPS

App. Status:        Up

App. Status Desc:

App. version:       7.0(7)E4

Data plane Status:  Up

Status:             Up

Mgmt IP addr:       10.0.0.54

Mgmt Network mask:  255.255.255.0

Mgmt Gateway:       10.0.0.254

Mgmt Access List:   10.0.0.0/24

Mgmt Access List:   10.0.0.254/32

Mgmt web ports:     443

Mgmt TLS enabled:   true

then I tried to change the IP address I get 

FWall# session 1 ip address 10.0.0.15 255.255.255.0

ERROR: Timeout waiting for a command response from slot 1

[David Kosek]

Why not change the IP of the other divice, log in to the IPS change its address and then change the other device back.?