Re: I'm looking for Failover/High available solutions for IPS 42
I do not know if this is documented anywhere, but I can tell you what I do. As long as the IPS 4200 has power, with the right software settings, the unit can fail such that it will pass traffic. Should the unit loose power, it does stop all traffic. I run a patch cable in parallel with the in line IPS unit, in the same VLAN, with a higher STP cost. Thus all traffic will traverse the IPS unit when possible, but should something happen to it, a $10 patch cable takes over.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...