I have ASA 5510 installed with ASA ssm 10 IPS module. This module was faulty and got today RMA from Cisco. It comes with the below image pre-installed.
sensor# sh ver Application Partition:
Cisco Intrusion Prevention System, Version 5.0(2)S152.0
OS Version 2.4.26-IDS-smp-bigphys Platform: ASA-SSM-10 Serial Number: JAF114604ES No license present Sensor up-time is 41 min. Using 472633344 out of 1054670848 bytes of available memory (44% usage) system is using 17.3M out of 29.0M bytes of available disk space (59% usage) application-data is using 35.6M out of 166.8M bytes of available disk space (23% usage) boot is using 40.5M out of 68.6M bytes of available disk space (62% usage)
I like to upgrade it to IPS-SSM_10-K9-sys-1.1-a-7.0-1-E3.img because another primary ASA module has the same image running.below is the exsisting working module image. shall i use the sensor cli cmd "upgrade " TO UPGRADE IT. If not pls give the steps for the upgrade.
Primary ASA# sh module 1 details
Getting details from the Service Module, please wait...
ASA 5500 Series Security Services Module-10
Hardware version: 1.0
Serial Number: JAF1335AMJP
Firmware version: 1.0(11)5
Software version: 7.0(1)E3
MAC Address Range: 0026.0bde.4318 to 0026.0bde.4318
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :