I've been handed an IDS 4210 and asked to put it in production. I don't have experience with IDS and am not sure how to arrive at a desired result and how the device should be configured. Is it possible to receive a config guide or admin guide as well as any suggestions as to how to determine if the device is functioning properly once implemented? Thank you in advance.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...