04-18-2012 12:19 AM - edited 03-10-2019 05:39 AM
Hi,
I am facing problem with cisco IDS 4215 (version 6.0), date and time of appliance change after reboot. What is command for save configuration. save or write mem is not working.
Amarjeet Singh
Solved! Go to Solution.
04-18-2012 04:29 AM
Once the date/time changes are applied from Cisco IPS CLI, they should have been saved. No additional step of "saving" manually is needed.
Also, have you considered configuring NTP server on IPS. IPS will sync up time with NTP server, if there is any difference.
I would suggest you to contact Cisco TAC and report the hardware issue.
Regards,
Sawan Gupta
04-18-2012 04:29 AM
Once the date/time changes are applied from Cisco IPS CLI, they should have been saved. No additional step of "saving" manually is needed.
Also, have you considered configuring NTP server on IPS. IPS will sync up time with NTP server, if there is any difference.
I would suggest you to contact Cisco TAC and report the hardware issue.
Regards,
Sawan Gupta
04-18-2012 09:51 PM
Thanks Sawan. i had open appliance and replace CMOS battery, problem has been solve.
Amarjeet
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide