Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IDS 4215 date and time change after reboot

Hi,

I am facing problem with cisco IDS 4215 (version 6.0), date and time of appliance change after reboot. What is command for save configuration. save or write mem is not working.

Amarjeet Singh

  • Intrusion Prevention Systems/IDS
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

IDS 4215 date and time change after reboot

Once the date/time changes are applied from Cisco IPS CLI, they should have been saved. No additional step of "saving" manually is needed.

Also, have you considered configuring NTP server on IPS. IPS will sync up time with NTP server, if there is any difference.

I would suggest you to contact Cisco TAC and report the hardware issue.

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta
2 REPLIES
Bronze

IDS 4215 date and time change after reboot

Once the date/time changes are applied from Cisco IPS CLI, they should have been saved. No additional step of "saving" manually is needed.

Also, have you considered configuring NTP server on IPS. IPS will sync up time with NTP server, if there is any difference.

I would suggest you to contact Cisco TAC and report the hardware issue.

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta
New Member

IDS 4215 date and time change after reboot

Thanks Sawan.  i had open appliance and replace CMOS battery, problem has been solve.

Amarjeet

378
Views
0
Helpful
2
Replies