Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IDS 4215 WebUI access and password

Referring to

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Intrusion%20Prevention%20Systems/IDS&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddcde2a

A- I can telnet to the IDS (at work) , but I am trying to figure out why I can not access the web interface (tiny window was popped up), I tried default username and password which are cisco without any sucess.

A/1- How can i find that (current username and password) ? I have issued show configuration, but I could find nothing!!!

A/2- Do I need to assign username and password for the web interfaces access ?

B- Does a console cable for an IDS is something different from th a console cable for a router ?

[quote]For RJ-45 connections, connect a [b]180/rollover[/b] cable[/quote]

http://cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df80.html

C- I tried console cable for a router without success.

Regards

4 REPLIES

Re: IDS 4215 WebUI access and password

A- I can telnet to the IDS (at work) , but I am trying to figure out why I can not access the web interface (tiny window was popped up), I tried default username and password which are cisco without any sucess.

- Try default 'cisco/cisco'. But you normally need to change the default password (cisco) when initializing it. Default username/pwd is cisco/cisco. HTTPS is enabled by default.

A/1- How can i find that (current username and password) ? I have issued show configuration, but I could find nothing!!!

- From the CLI, issue "sh user all". You should be able to see user account (if configured).

Otherwise, create new account(s) using :

sensor(config)# username operator01 password my2centpwd priv operator

sensor(config)# username admin911 password 3mer9ing5 priv administrator

A/2- Do I need to assign username and password for the web interfaces access ?

- No, you can use available user account/ID. But it's good to have user ID with admin privileges for testing purposes.

B- Does a console cable for an IDS is something different from th a console cable for a router ?

- No, it should be the same

HTH

AK

New Member

Re: IDS 4215 WebUI access and password

Thanks for that AK, I was able to access WebUI by using same username and password for the telnet.

[cut]

- No, it should be the same

[/cut]

Is there something else, i have to be aware of it

Gold

Re: IDS 4215 WebUI access and password

Maybe IDM access is not working thanks Java problem

Try following download java 1.4.2_07

https://sdlc5b.sun.com/ECom/EComActionServlet;jsessionid=5BED10CBB25347782DC40CB6AE5ECDF1

and then set the following as below in Java

Step 1 Close all instances of Internet Explorer or Netscape.

Step 2 Choose Start > Settings > Control Panel.

Step 3 If you have Java Plug-in 1.4.2 installed:

a. Click Java Plug-in.

The Java Plug-in Control Panel appears.

b. Click the Advanced tab.

c. Enter -Xmx256m in the Java RunTime Parameters field.

d. Click Apply and exit the Java Control Panel.

Now try to connect to the IDM via https

M.

Hope that helps rate it does

New Member

Re: IDS 4215 WebUI access and password

Thanks M for this explanation, I am pretty sure that we are going to use these steps one day with a specific PC ?

419
Views
0
Helpful
4
Replies
CreatePlease to create content