Hi .. For IDS .. you would configure one interface on the IDS as the sensing (monitoring) interface. On the switch you would have to SPAN the trunk carrying the VLANs so that the destination of the SPAN points to the port where the IDS is connected. A second interface on the IPS can be used for TCP resets and you need to plug this one on another trunk port on the switch.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...