Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

IDS/IPS detects outgoing traffic?

I have 4215 appliance that I'm trying to get working. It's only logging the outbound traffic. I'm not sure what I need to configure to have it log the incoming traffic (which is what I thought the device was intended to do). Any/all ideas would be greatly helpful to me.

Thanks!

1 REPLY
Community Member

Re: IDS/IPS detects outgoing traffic?

Hey-

I am not an expert by any means, but I have a 4215 and I think it has to do with the egress/Ingress setting. If I remember correctly the switch that my 4215 is plugged into you have to set egress/ingress on each port you have to monitor?

Ingress and Egress = Entrance and departure

Hope this helps

174
Views
0
Helpful
1
Replies
CreatePlease to create content