Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

IDS Sec Mon - no alarms

Does anyone know why Sec Mon will not populate any new alarms? Audit log shows: Alert Inserter Error (Insert Thread) - setStrValue: too many chars for target | Alert Inserter disconnecting from database and exiting

How do I correct this problem? Version 5.1(5)E1 on sensors Sec Mon 002.002 (000.315) Thanks

2 REPLIES
New Member

Re: IDS Sec Mon - no alarms

Found the problem - one sensor was sending a long message and triggering the failure

New Member

Re: IDS Sec Mon - no alarms

We now have the same problem. Could you provide some details on the solution, e.g. what signature that actually causes the failure?

Thanks,

/Ola

128
Views
0
Helpful
2
Replies
CreatePlease to create content