Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

IDSM-2 and inline mode

Hello

I have a question about IDSM-2 (in catalyst 6500) and ips 6.0.3 and inline mode. I wanted to create vlan groups, so i could have inline ips with many virtual sensors for subinterfaces (vlans range).

I tied to:

set trunk 5/7 1-4095 (on swith)

set trunk 5/8 1-4095 (on swith)

and in IDSM-2 in CLI:

i created inline interface (using 5/7 and 5/8 ports), but after that i could not create in physical interface vlan groups. Why ?

How can i make my IDSM-2 card working inline with many virtual sensors (policies) per different vlans ?

168
Views
0
Helpful
0
Replies
CreatePlease to create content