Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM-2 error

Received follow error after service module was restarted:

From diagnostics event -

07/13 13:08:10.573 E [2] komodo_plus_lb_pc_port[2/7]: check_ether_packet failed (err-code 43)

From sh log -

Jul 13 13:04:34: SP: The PC in slot 2 is shutting down. Please wait ...

Jul 13 13:05:04: SP: PC shutdown completed for module 2

Jul 13 13:05:14: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Reset)

Jul 13 13:08:09: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimal Diagnostics..

.

.Jul 13 13:08:11: %HA_EM-6-LOG: tmpsys:/eem_policy/Mandatory.go_bootup.tcl: GOLD

EEM TCL policy for boot up diagnostic

Jul 13 13:08:11: %DIAG-SP-3-MAJOR: Module 2: Online Diagnostics detected a Major

Error. Please use 'show diagnostic result <target>' to see test results.

Jul 13 13:08:11: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 2: TestPCLoopback fai

led on port(s) 3-4

Jul 13 13:08:11: %OIR-SP-3-LC_FAILURE: Module 2 has Major online diagnostic fail

ure, Card will be powered reset to re-run diagnostic. Please check sup-bootflash

diaginfo file for previous detailed diagnostic resu

Jul 13 13:08:12: %OIR-SP-3-PWRCYCLE: Card in module 2, is being power-cycled off

(Diagnostic Failure)

Jul 13 13:08:12: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Diagn

ostic Failure)

Jul 13 13:11:38: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimal Diagnostics..

.

.Jul 13 13:11:40: %HA_EM-6-LOG: tmpsys:/eem_policy/Mandatory.go_bootup.tcl: GOLD

EEM TCL policy for boot up diagnostic

Jul 13 13:11:40: %DIAG-SP-3-MAJOR: Module 2: Online Diagnostics detected a Major

Error. Please use 'show diagnostic result <target>' to see test results.

Jul 13 13:11:40: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 2: TestPCLoopback fai

led on port(s) 3-4

3 REPLIES
Gold

Re: IDSM-2 error

Looks like your IDSM is sick. I'd open a TAC case to get it RMA'ed.

Re: IDSM-2 error

Try removing it from the chassis once and then reinsert.

If that does not work, and you cant re-image the module by any menas, go for RMA, as mentioned by the first responder.

Regards

Farrukh

New Member

Re: IDSM-2 error

Reseat was my first option as we couldn't access the module. Temporarily indicates good condition but then fails.

Replacement module on route.

584
Views
0
Helpful
3
Replies
CreatePlease to create content