1. Is it possible to associate 2 vlans( to be paired) on 2 different data ports on IDSM instead of pairing it on single data port on IDSM ?? & configuring these 2 ports on CAT6509 as access ports instead of trunk... Will this thing work ?
2. Since bypass mode is ON by default(AUTO) in IDSM-2 in-line vlan pair mode but when I am testing the bypass its not happening..can any pls. guide what could be the reason for this ?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...