I have to do password recovery for IDSM-2. I have read the document available for password recovery. It shows that i have to re-image the IOS because i am unable to log into IDSM-2. Will Re-image will disturb the normal communication of the switch and other modules however IDSM-2 is not being used at all. Is downtime is required for IDSM2 i mean it will be a fresh installation of IDSM-2
Talha it depends on your setup. What else are you using, FWSM? What is the user's default gateway? (SVI on core switch, SVI on FWSM etc.)? Are you using multiple IDSM(s) through ether-channel load-balancing?
1) Application partition - this is what you will be re-imaging. It is what runs the IPS s/w, inspecting traffic and generating alerts.
2) Maintenance partition - a partition that runs from CF on the idsm2 (switch reset command with cf:1 added to boot into this partition). After booting into this partition you will be able to re-image the AP and then reset the idsm2 and boot up into the AP where you can enter the default cisco user/PW.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...