Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

IDSM-2 Re-Image

I've ran in troubles after IDSM booted up into maintenance partition. IDSM-2 is refusing session from switch running native IOS and unresponsive. Any quick solution for this problem? TAC is the only resort / could be a HW problem?

1#ses slot 2 proc 1

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

Trying 127.0.0.21 ...

% Connection refused by remote host

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

2 0003.xxxx.xxxx to 0003.xxxx.xxxx 4.0 7.2(1) 1.3(2)m Ok

Thanks

1 REPLY
Silver

Re: IDSM-2 Re-Image

There is no problem with the hardware. Changing the boot parameter from cf:1 to hdd:1 worked for me 1.e from Flash to hard disk

156
Views
0
Helpful
1
Replies
CreatePlease to create content