06-16-2008 11:20 PM - edited 03-10-2019 04:09 AM
Hi,
I am upgrading IDSM-2 image from v5 to v6 (IPS-K9-6.0-4a-E1.pkg) after this upgrade do we need to go for the Upgradation of Recovery Partition ?
Thank you,
Dinesh
Solved! Go to Solution.
07-19-2008 04:26 AM
Hi,
Every thing is same as shown in document, but i am not able to see any logs, If i keep same vlan on SPAN logs are there.
Any trouble shooting steps or tools are there ?
07-19-2008 09:03 AM
If you Inline VLAN Pair is not functional, then no traffic will pass through anyway. You can try to ping between any two devices in the 'bridged' VLANS.
Regards
Farrukh
07-22-2008 09:34 PM
My configuration is like this,
firewall vlan-group 2 10,100
Vlan 10 Inside & Vlan 100 is outsie interface of the FW Context,
I created on L2 Vlan 101
and added this VLAN (10 and 101) in VLAN PAIR config and this interface giga 0/8.1 (Subinterface). same interface is config for Virtual Sensor 0.
I dont have problem with traffic but not able to see any logs.
07-23-2008 11:04 PM
Hi
07-26-2008 02:58 AM
In which mode is the sensor operating?
Auto/Bypass etc.
Regards
Farrukh
07-27-2008 11:16 PM
It is in Auto (Bypass inspection when analysis engine is stopped.)
Is this will create a problem ? or do we need to change it to ON & OFF.
07-27-2008 11:21 PM
Nah Auto is fine. Can you post the configs? (show config)
Regards
Farrukh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: