Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM configuration help

hi,

I will configure an idsm module (S/W version 6) in switch 6500 for the first time so , can i configure the module through IDM ( i.e graphical interface) like any sensor device or not??? and How can i do this??

best regards

Mohamed

1 REPLY
Silver

Re: IDSM configuration help

The basic configuration has to be done via the CLI have a look at http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a0080459221.html

It should be similar for 5.X and 6.X.

Then you could login through your web interface to configure this as you do the appliance.

-Hoogen

Do rate if you find this post helpful :)

116
Views
0
Helpful
1
Replies
CreatePlease to create content