Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM error

When show module is used it says "module failed SCP dnld" for the IDSM module.Also the status says PwrDown.I believe it's a power problem but what does the above error indicate?

1 REPLY

Re: IDSM error

It could be a firmware/hardware version issue pertaining to the IDSM, or you are not running the required version on your host device (cat6k .. )

Can you post the output of the 'show module' command?

Was this working before or it never has worked?

Regards

Farrukh

127
Views
0
Helpful
1
Replies