Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

IDSM monitoring command

Which command is used for checking the monitoring method sed in IDSM say SPAN, RSPAN, VACL...

1 REPLY

Re: IDSM monitoring command

You have to look at the switch configuration to check the configuration. From the IDSM side alll three are equal.

SPAN/RSPAN can be verified by entering the following on the switch:

show monitor session

and

show run | inc intrusion

Regards

Farrukh

141
Views
0
Helpful
1
Replies
CreatePlease to create content