10-19-2007 01:46 PM - edited 03-10-2019 03:50 AM
How to login to IDSM (6513 box) by recoverning the passwd.
10-19-2007 02:05 PM
Password Recovery is only supported with IPS 6.0. During password recovery you can reset the cisco user password back to default cisco without losing any of the configuration on the sensor.
If you are running IPS 6.0, then you would need to boot to the Maintenance Partition and run a special file that will just reset the password on the Application Partition.
Instructions are available here:
If you are running IPS 4.x, 5.0, or 5.1; then there is no password recovery option that only changes the password. You would instead just have to boot to the Maintenance Partion and load a completely new System Image on the sensor.
The new System Image will reformat the Application Partition and load a completely new image. All configuraiton would be lost. I will reset the cisco user password to default cisco, but at the cost of also losing all of your sensor configuration.
10-23-2007 01:45 AM
What are the other steps other than these,
1.Boot to maint. partition
2.Upgrade by connecting to the FTP where passwd. recovery image is placed using upgrade command.(Here we can specify the new passwd)
3.Reload to application partition
10-23-2007 06:54 AM
Boot to maint partition
Download the following file from cisco.com and place on an ftp server:
WS-SVC-IDSM2-K9-a-6.0-password-recovery.bin.gz
Located here on cisco.com:
http://www.cisco.com/cgi-bin/tablebuild.pl/ips6-cat6500-idsm2-sys
From the main partition execute the upgrade command to download and install that special password recovery file.
Boot to the application partition (this may be done automatically).
Login with cisco userid and default "cisco" password.
You will be prompted to enter the default "cisco" password again, and then be prompted for the new password.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: