IDSM SPAN and filter on destination

[hoffa2000]

Greetings

When I set up a SPAN session with a regular TP interface as a destination I am able to allow specific VLANs on the destination trunk port. This does not work for me when I try the same setup with the IDSM data port as the destination. Has anyone got this working?

I have IOS 12.2SXF5 on the 6513 and 6.0(4)E1 on the IDSM.

Regards

Fredrik

[marcabal]

This does not work for the IDMS-2.

The trunk configuration of the IDSM-2 does NOT work in conjunction with setting the IDSM-2 as a span destination port.

The trunk setting of the IDSM-2 is only used when configuring the IDSM-2 for InLine Vlan Pairs.

For Span monitoring the IDSM-2 needs to be configured for Promiscuous mode and so the Trunk configuration is not used.