Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM2 (5.0) Implementation

Hi everyone,

I have the following case:

2 x Cat6509 (HSRP master and slave)

2 x IDSM blades (v5.0 - 229)

each Cat has his own IDSM blade install online (not inline), with 2 monitoring sessions on each Cat.

There is any way to monitor traffic over 600 Mbps in those 2 different blades?

Regards,

5 REPLIES

Re: IDSM2 (5.0) Implementation

The IDSM only can process 600 Mbps. You could perhaps divide the load by inspecting different VLANs on each IDSM using access maps.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008007e70d.html#wp1055516

I hope it helps .. Please rate it if it does !!!

New Member

Re: IDSM2 (5.0) Implementation

uuuTt

New Member

Re: IDSM2 (5.0) Implementation

I have doubts that 2 IDSM2 blades can’t cover traffic around 300 Mbps as I can’t get from the SNMP statistics. That’s way I was asking how 2 blades can be configure without having problem with interVLAN traffic.

FYI

evStatus: eventId=1136715333146415062 vendor=Cisco

originator:

hostId: Cisco-IDSM2-1

appName: interface

appInstanceId: 425

time: June 7, 2006 7:34:01 AM UTC offset=180 timeZone=GMT+02:00

netInterfaceMissedPacketThresholdExceeded:

description: GigabitEthernet0/7 : Missed-packet threshold was exceeded. 912% of packets were missed.

interfaceName: GigabitEthernet0/7

Rgds

New Member

Re: IDSM2 (5.0) Implementation

I have doubts that 2 IDSM2 blades can’t cover traffic around 300 Mbps as I can’t get from the SNMP statistics. That’s way I was asking how 2 blades can be configure without having problem with interVLAN traffic.

FYI

evStatus: eventId=1136715333146415062 vendor=Cisco

originator:

hostId: Cisco-IDSM2-1

appName: interface

appInstanceId: 425

time: June 7, 2006 7:34:01 AM UTC offset=180 timeZone=GMT+02:00

netInterfaceMissedPacketThresholdExceeded:

description: GigabitEthernet0/7 : Missed-packet threshold was exceeded. 912% of packets were missed.

interfaceName: GigabitEthernet0/7

Rgds

New Member

Re: IDSM2 (5.0) Implementation

Hi

all depends on your topology.

- if it's possible you can make 1st Cat be master for 1st half of routed vlans, 2nd Cat for 2nd half splitting traffic load between chasis and two IDSMs

or

- try to play with span/rspan/vacl redirects,

dcsrnd.pdf is your friend

tk

172
Views
0
Helpful
5
Replies