Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Informational events in security monitor

I am looking for the configuration method so that the VMS security monitor will display informational events in addition to low, med., and high events..

The documentation I have found explains what the informational event is, but I cannot find out how to enable it in security monitor..

thanks!

2 REPLIES
New Member

Re: Informational events in security monitor

It should display all events unless you have an event viewer filter. An event viewer filter can be configured for example to only show high severity events.

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/mon_sec/secmon20/ug/ch04.htm#wp322119

New Member

Re: Informational events in security monitor

Thanks. That pointed me in the right direction.

Within SM, under the Devices tab, I had to choose

a device, click on edit, then change the

minimum event level to informational.

129
Views
0
Helpful
2
Replies
CreatePlease to create content