There is no HA mode or function for any of the IPS Sensors. If you run a pair of sensors with the same configurations (except sensor name and IP address of course) and pass statefull traffic thru each (like per-destination load balancing for active/active) you should be fine.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...