Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

IPS 4215 Issue

Hi..

We have upgraded IDS 4215 to IPS version 5.1 at one of our clients. And now we have oput it in inline mode. Scenario is as follows::

Location A is connected to location B with IPS coming after router and then Firewall and then the DMZ...When i m trying to check by doing ping from location B to Location A's servers in the DMZ...noe of the icmp packets are recorded in the logs...the signature for the same is enabled though...Is there any other porblem..Configuration is absolutely ok..Can anybody suggest...

In addition..traffic matching the default signatures is also not getting logged...Plz suggest....

2 REPLIES
Silver

Re: IPS 4215 Issue

Once you put the sensor inline, you must remember to add the interface pair to the virtual sensor. I would check this first. Which signature are you looking for?

New Member

Re: IPS 4215 Issue

I already have done the same when I put it in inline mode...

i was trying for icmp request and reply signatures...but it didn't work when i tested with a ping...In addition default signatures are also not getting fired..in fact nothing is shown in IPS logs...I wonder...

ANything suggestive??

129
Views
0
Helpful
2
Replies
CreatePlease to create content