Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

IPS 4240 is not booting

Cisco IPS 4240 not booting now. when trying from Hyper Terminal the following message only coming

System Booting Please wait .....

System suddenly hang-up, the same error getting after power restart.

Thanks,

M.Nagarajan

1 REPLY
Community Member

Re: IPS 4240 is not booting

Check out the thread titled: IDS-4235 boots to GRUB after applying 6.0(3)E1...

I had to go to the ROMMON and from there set the IP,mask,gateway and tftp the recovery image (which gives you a pretty much an unconfigured device, unless there's something that you can do out of the recovey mode).

This link should be of help: http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a00807517ba.html#wp1060091

418
Views
0
Helpful
1
Replies
CreatePlease to create content