I am fairly new to the IPS world and am currently setting up an IPS for Promiscious mode. When installing this device on G0/1 interface what should the port be configured for on the other end? Access, Trunk, or Span port? I want it to monitor all data passing through that switch if possible.
The port connected to the 'sensing interface' of the IPS sensor will be the SPAN destination port. Please see the last link for characteristics of SPAN ports. You can send all traffic from a range of ports (even trunk ports) or a number of VLANs to a particular port.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...