Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPS 4260

Hi,

I have a IPS 4260 running Version 6.0(5)E2.One of the sensing interface is "UP", but the data is not flowing through. from "show tech-support":

-Missed Packet Percentage = 100

However,the link status is "UP". How is the possible problem, and how i can retify?

thanks in advance.

cash

1 REPLY
Gold

Re: IPS 4260

Was this a working sensor or is this a new install?

For new sensors, I usualy forget to add the sensing interface to the virtual sensor (I;m not sure that'll give you a 100% missed packet stat though). Try these commands:

conf t

service interface

physical-interfaces gigabitEthernet0/1

admin-state enabled

exit

exit

service analysis-engine

virtual-sensor vs0

physical-interface gigabitEthernet0/1

For existing sensors, a reload can clear up many problems.

146
Views
0
Helpful
1
Replies
CreatePlease login to create content