12-01-2005 02:59 PM - edited 03-10-2019 01:47 AM
Hi
I want to start with deploying new IPS 4240 device. I want to find out is there any gui based management software which can make the initial config easy. I am trying to follow CLI at present.
Thanks for your help.
regards
Rakesh
=====
12-02-2005 02:33 AM
Hello Rakesh,
You can configure the IP address initially using the CLI and go ahead and use the IPM to configure the IPS. I have attached a document which clearly shows the configuration of IPS.
You can also refer to the following URL:
Hope this helps. rate replies if found useful.
Raj
12-02-2005 02:43 PM
greate. Thansk Sachin. Is it enough for most deployment to keep default value of 'Action' in the signature?
regards
Rakesh
======
12-03-2005 07:19 AM
The signatures all have a default action which is based on Cisco's IPS signature team's recommendation.
However each environment will be different and you may decide that there are some signatures that you want to have an action to 'Alert' only, and there may be others where you want to block, or deny-inline, or capture the triggering packet. It all depends on what you want to accomplish.
12-03-2005 09:41 AM
Thanks Jeffery. ONe more questioin.. does it detects virus within emails too?
regards
Rakesh
======
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide