The Virtual Sensors page is where you create, name, and configure virtual sensors on your Cisco IPS devices. A virtual sensor is a logical grouping of sensing interfaces and the configuration policy for the signature engines and event action filters to apply. The process of creating and naming virtual sensors on your Cisco IPS devices is sometimes called "virtualization." Virtualization is the separation of a single physical IPS device into two or more logical devices on the basis of port, IP address range, VLAN tag, and other criteria
tread carefully, Cisco doesn't appear to quite have all the kinks worked out of virtual sensors. The last upgrade deleted any that didn't start with "sig"...so all ours were deleted. a fix is imminent for this particular issue.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...