sensor(config)# recover application-partition Warning: Executing this command will stop all applications and re-image the node to version 6.2(1)E3. All configuration changes except for network settings will be reset to default. Continue with recovery? :
The application partition is reimaged using the image stored on the recovery partition. You must now initialize the sensor with the setup command.The IP address, netmask, access lists, time zone, and offset are saved and applied to the reimaged application partition.
You can always save your image and then uploaded to the sensor again. Is this what you're looking for?
The 'recover application-partition' command reverts the sensor to factory defaults to the version indicated in the 'show version' output's Recovery Partition entry. This will remove any added user accounts, and revert the default cisco account. It does not revert settings from the 'service host' section of the configuration; this ensures you should still be able to access the sensor remotely.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...