Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPS and Switch problem

Dears,

i need to use commands:

monitor session 1 source interface Fa0/1 - 23

and

monitor session 1 destination interface Fa0/24

but when i put the second command i lost the connection with IPS sensor......what is the problem?

thank you.

1 REPLY
Silver

Re: IPS and Switch problem

By making your port a SPAN port to in essence mirror all traffic to the destination port from your source port(s). You cannot interact on the destination port. I mean that the destination port does not function as an access port anymore until you remove the SPAN from it. You need to find an alternate path to your IPS. Either from the outside or console....

107
Views
0
Helpful
1
Replies
CreatePlease login to create content