I have a number of 18xx, 19xx, 28xx and 29xx isr's. I am wanting to know if someone makes any configuration changes to any of them. I have used what's up gold to send gather custom snmp traps and send email alerts when this happens and that works fine. I am also wanting to know if cisco ips will do the same thing, that is, send an alert when someone makes a configuration change on the isr.
I do not think there are any configuration change traps on the IPS OS. You can check for yyourself"
The following private MIBs are supported on the sensor:
Note MIB II is available on the sensor, but we do not support it. We know that some elements are not correct (for example, the packet counts from the IF MIB on the sensing interfaces). While you can use elements from MIB II, we do not guarantee that they all provide correct information. We fully support the other listed MIBs and their output is correct.
You can obtain these private Cisco MIBs under the heading SNMP v2 MIBs at this URL:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...