Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPS design question

Hi All,

I have two ASA as active/standby failover. these two are connected to 3750 switch through trunk port that carry vlan 10,20 and 30. I want to deploy IPS in between with inline mode. I am little confuse how to connect IPS here. should it be connected with both two ports to switch, or it should be connected to ASA from one end and then connected to switch with another end.

If you show me how to connect IPS here, that would be very appreciated.

thanks

Alex

1 REPLY

Re: IPS design question

With inline vlan pair only one IPS interface is utilized (it has to be a trunk), have a look at:

http://www.cisco.com/en/US/products/sw/secursw/ps2113/products_configuration_example09186a0080876d9f.shtml

Regards

Farrukh

134
Views
0
Helpful
1
Replies
CreatePlease login to create content