Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPS Device Type: ASA5585-SSP-IPS10 and Enabled Signature

Good evening

I have in produciton 2 Cisco IPS Device Type: ASA5585-SSP-IPS10 IPS Version 7.1.4(E4) with signature version 664.0

I have enabled on Sensor1 a few signatures and after I had to enable the same signatures on Sensor2, by flag individual check box also on Sensor2 (by Configuration -->Policies); is there a procedure (or task by IME 7.2.1 ) which can duplicate the signatures enabled on sensor1, also on Sensor2?

Thanks in advance

Best Regards

--

Giovanni Davide Saccà

1 REPLY

IPS Device Type: ASA5585-SSP-IPS10 and Enabled Signature

Hello,

You will need to perform that manually, there is no way you can do it dinamically as depending on each signature file you are using there are going to be some enabled and others not.

Regards,

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
448
Views
0
Helpful
1
Replies
CreatePlease login to create content