Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

IPS Exemption filter

Hi All,

Can anybody know that how to add policy in the IPS GUI so that I can permit traffic from a particular source/Destination.

As our IPS is dropping some traffic while network scanning but we need to allow that traffic to reach its destination.

Thanks & Regards,
Rahul Chhabra 
Network Engineer 
Spooster IT Services

1 REPLY
New Member

What you are looking for is

What you are looking for is called an "Event Action Filter". So edit your policy and then add the event action filter to add the IP addresses of your scanner and filter out the deny, reset, blocks, etc.

68
Views
0
Helpful
1
Replies
CreatePlease to create content