Check the interface configuration for Link Duplex configuration as the command "show tech-support" will show the interface parameters as per the configuration done. So the output of this command completely depends on the configuration that has been done and is existing. So when the interface is configured as "full" for link duplex it will show as full and not the other way.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...