Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPS interface statistic reset

hi,

How can I reset theinterface statistic on y IPS devices?

Thanks

2 REPLIES
Cisco Employee

Re: IPS interface statistic reset

Most of the interface statistics in "show interface" are MAC level (hardware) statistics and cannot be reset except by rebooting the sensor.

The higher level statistics, such as "show statistics virtual-sensor" can be reset by appending the keyword "clear" to the request. In that case, the current statistics are displayed and then reset internally. The next invocation will show statistics since the "clear". One of the statistics is "Seconds since last reset" and you can use it to verify that your reset is taking place.

Cisco Employee

Re: IPS interface statistic reset

Further info. You can apply the "clear" attribute to the Show Interfaces command and reset everything but the Management interface. The appropriate math is being done under the covers for the data interfaces.

156
Views
0
Helpful
2
Replies