cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
486
Views
0
Helpful
1
Replies

IPS Manager

Hi,

I've Cisco Security Manager Suite with IPS Manager.

I want to add a sensor...I go to Devices->Sensor as suggested by User Guide.

But when I open the page i don't have the Add function, but only Re-Import and Reboot...

Why?

I've not powered on the sensor...

The sensor is IDSM-2 module installed on a Catalyst 6500.

Thank you for your reply.

Best regards.

Massimiliano.

1 Reply 1

hadbou
Level 5
Level 5

To add a sensor, use Cisco Security Manager. Adding a sensor to Cisco Security Manager automatically adds it to IPS MC.When you add a device to Security Manager, you specify the identifying information for the device, such as its DNS name and IP address. This information is added during device discovery. You can also bring in existing network configurations associated with a device by initiating policy discovery. The sensor should be powered on to be added to the device inventory. So power on the device and then try the same steps as done before.

http://www.cisco.com/en/US/docs/security/security_management/cisco_security_manager/ips_manager/3.0/user/guide/ch05.html

http://www.cisco.com/en/US/docs/security/security_management/cisco_security_manager/security_manager/3.2/user/guide/ivman.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: