Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

IPS question for ASA 5525-X's

I am used to dealing with the separate SSM-10,20 or 40 modules that go in the non-X version of the ASA's.  In those, even in an active standby configuration, you had to individual configure each IPS sensor (even on the standby unit) since the IPS configuration wasnt synchronized between ASA's like the ASA configuration is.

Is the IPS configuration now a part of the 5525-X config or will I still be looking at configuring the IPS separately like I am used to doing ?

Ron                  

Everyone's tags (2)
1 REPLY

IPS question for ASA 5525-X's

Hello Ronald,

It needs to be done on the same way, no replication between IPS modules,

Regards,

Remember to rate all the helpful posts

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
810
Views
0
Helpful
1
Replies
CreatePlease to create content