Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPS status LED stays red

Dear Friends,

There is a IPS 4260 that reports the status LED to red. When reading the hardware installation guide, i came to know that this indicates a POST failure. I forced a POST again of the IPS by rebooting the IPS but i could not capture any significant error.

However, i am enclosing the captures of the boot process (Filename: IPS) and the sh tech-support (Filename: IPS Tech support).

Can you please help me on this?

Thanks a lot

Regards

Gautam

1 REPLY
New Member

Shutdonw the IPS for 5 - 10

Shutdonw the IPS for 5 - 10 Minutes and the Restart i did and the issue has been resolved .

Thanks,

Mustafa 

415
Views
0
Helpful
1
Replies