IPS status LED stays red

[gautamzone]

Dear Friends,

There is a IPS 4260 that reports the status LED to red. When reading the hardware installation guide, i came to know that this indicates a POST failure. I forced a POST again of the IPS by rebooting the IPS but i could not capture any significant error.

However, i am enclosing the captures of the boot process (Filename: IPS) and the sh tech-support (Filename: IPS Tech support).

Can you please help me on this?

Thanks a lot

Regards

Gautam

[ITNIS-AWCC]

Shutdonw the IPS for 5 - 10 Minutes and the Restart i did and the issue has been resolved .

Thanks,

Mustafa