Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ISDM2 with FWSM configuration example

Hi there,

We're trying to implement isdm2 as inline mode integrated with fwsm module. We have two vlans on the switch: vlan 30 is responsible to take care the outside interface of the lab context of fwsm while vlan 40 is responsible from the inside interface. How can i implement a correct configuration in order to use isdm2 to inspect traffic ? There are several documents on the net, but i'm really confused with them and no one is clear enough.

P.S: At the moment we're using isdm2 in promiscous mode with the following configuration :

intrusion-detection module 3 data-port 1 capture

intrusion-detection module 3 data-port 1 capture allowed-vlan 30

Thanks in advance.

1 REPLY
Silver

Re: ISDM2 with FWSM configuration example

The IDSM2 is supported in inline mode, provided that the switch has a sup720 running 12.2(18)SXE (or later) or a sup32 running 12.2(18)SXF (or later).

Refer these link for configuration doc:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/cliguide/cliidsm2.htm

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids10/hwguide/index.htm

452
Views
0
Helpful
1
Replies
CreatePlease to create content